Composite Doors: Sizes

This is for the size in Millimetres (mm) that you would like the door manufactured to. This size is to include any Cill and will be manufactured to tolerances of 2-3mm. Please ensure the sizes provided are not tight brickwork opening sizes as your new door may not fit, always allow a tolerance of about minus 10mm in the width and minus 10mm in the height. (Reduce size further if your opening is not square, out of level or has protruding bricks as your new door must be installed square, level and plumb).

Assumptions:

1. Doors and a single side panel - the door will be set at 900mm measured from the outside edge of the frame to the outside edge of the frame.
   
   
2. Door and two side panels - the door will be set at 900mm (assumed width of door will alter to 900mm or minimum size allowed for door panel if chosen and no other size given) measured from outside edge to outside edge of the frame.
   
   
3. If the door and / or side panel (s) has a fixed pane above - the fixed pane will be set at 2100mm from the bottom of the outer frame / low threshold to the top of the door frame. If the overall height of the door frame including the fixed light above is too short for a 2100mm dimension, we will reduce this dimension accordingly.
   
   

4. Georgian bar, diamond and rectangular lead will be laid out according to our best practise.